Burning watts, watts tile, the axle is caused by what are the reasons?

The reason of burning bush, grinding shingles and holding axle are as follows: (1) The bearing bush is seriously lack of lubricating oil; (2) The lubricating oil is too dirty with mechanical impurities; (3) lubricating oil moisture exceeds a certain limit; (4) lubricating oil temperature is too high, can not play the role of lubrication; (5) oil viscosity is not enough or wrong grades; What are the hazards of burning tile, grinding tile and holding axle? The accident of burning tile, grinding tile or holding axle, if it is not found in time, will cause motor overload, then burn the motor, damage the pump parts and other adverse consequences. Therefore, in the event of such accidents, emergency stop pump should be dealt with immediately. Zeus pump related articles: What causes the pump power is too large? What are the causes of water pump vibration and noise? What is the phenomenon of water pump evacuated? Why centrifugal pump to close the outlet valve after the start? Centrifugal pump adjustment What method? Water pump does not start after the water is the reason? Vacuum vacuum gauge vacuum with a higher negative pressure should be how to deal with? Centrifugal pump power consumption is too large what? Centrifugal pump power consumption is too large What is the treatment method ? What is the reason note the total pump head is not enough to stop what causes the pump does not move the pump rotor disk is large injection pump noise of the top ten reasons: Yixing City, Zeus pump Co., Ltd., specializing in the production of corrosion resistant pumps;?? Desulfurization pump, chemical pump, self-priming pump, submerged pump, slurry pump and other products lining corrosion-resistant wear-resistant pump, corrosion-resistant pump features Zeus pump manufacturers. Copyright: Reprinted "What is the reason for burning bush, grinding tile, and holding axis?" The article must indicate the author and original source and link in the article.