Axle weight gauge, axle loader manufacturer, axle weight abnormality

Axle weight gauge, axle loader manufacturer, axle weight abnormality

2017-12-27Jiujin Weighing Apparatus Factory

1. There is no sound after the axle loader is turned on. It may be that the buzzer of the axle loader is broken, but it is also possible that some axle loader manufacturers set the switch parameters of the buzzer to save power. It's a good idea to check the instructions to see if you accidentally turned off the buzzer after entering the parameter settings. This is also a common occurrence.

2. There is sound after the axle loader is turned on, but the sound that appears when the sound is large or small, or there are hoarseness, etc., is basically caused by the badness of the axe of the axle loader itself.

Note:

1. Automatic accumulation function
After the vehicle passes through the weighing platform, we often need to know the number of axles and total weight of the vehicle and the axle weight of each axle, so that we can calculate whether the total weight and axle weight of the vehicle are overloaded. In the design of the meter , each time the up and down motion is detected, it is judged that one axis passes. The weight of the shaft is accumulated, and the uniaxial weight, the accumulated weight, and the axle weight are stored in the memory unit.

2. Closed judgment function
When the vehicle is weighed, it is often judged by the infrared finishing system . When the vehicle completely passes through the weighing platform , the infrared detects that the vehicle has left, sends a signal to the meter. After receiving the signal, the meter knows that the weighing has ended, and saves the weighing result as the final result of Zui or sends it to the computer. Therefore, the meter must have an I/O interface to accept incoming signals.